![]() ![]() Lowering of Voltages will give the LOW state. The voltage from VCC will start flowing the current from VCC to Ground through the transistor and this will lower the voltages on the A’. When input from the “A” is HIGH then the transistor will start flowing the current. There will be two conditions in which the circuit will operate. The base of the transistor will act as input and emitter will act as output. The transistor will be attached to the power supply and resistor. The transistor act as a switch and resistor use to change the max current flow. NOT gate is designed by transistors and resistors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |